Baumatic PI645 Manual do Utilizador descarregar pdf (Página 28)

must be tightened down firmly.

of the zones

work, you should recheck that the terminal screws are all

o T: The appliance must NOT be connected to the

ains supply by means of a 13A plug and socket.

o The cable can be looped if necessary, but make sure that is not

ble being in contact with hot parts of the

appliance.

supply cable

aced by an

opriate replacement.

mains supply cable should be replaced in accordance with the

o Open the terminal block on the underside of the hob.

o th

o eplace the cable with one of the same length and in accordance

o e terminal

arked

o The brass links must be positioned as marked in the diagram

the previous page and once established ALL terminal screws

o If when the hob is first switched on, only two

fully tightened between the links. This should be done

before contacting the Baumatic Service Department.

IMPORTAN

kinked or trapped when the hob is in position. Care must be

taken to avoid the ca

Replacing the mains

If the mains supply cable is damaged, then it must be repl

ppra

hT e

following instructions:

o Switch the appliance off at the control switch.

Unscrew e terminal screws fixing the cable.

with the specification given on page 26.

The “green-yellow” earth wire must be connected to th

m . It must be about 10 mm longer than the live and

eutral wires.

o he “black/blue” neutral wire must be connected to the terminal

arked with the letter (N) - the brown/red live wire must be

onnected to the terminal marked with the letter (L).

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Sem comentários

Baumatic PI645 Manual do Utilizador Página 28