Baumatic P75SS Manual do Utilizador

1P75SS/P76SS/PF75SSPythagora 75cm gas hobP90SS Pythagora 90cmgas hob

10Gas hob surface layoutP75SS, PF75SS & P90SSP76SS

11Using the gas hobIMPORTANT: You should clean the hob surface (see“Cleaning and maintenance” section).The following symbols will appear on the contro

12Energy saving tipso The diametre of the bottom of the pan should correspond to thatof the burner.o The burner flame must never extend beyond the dia

13CleaningCleaning operations must only be carried out whenthe hob is cool.The appliance should be disconnected from yourmains supply before commencin

14o IMPORTANT: Make sure that you reassemble the burners in theoriginal way.InstallationThe installation must be carried out by a CORGIregistered inst

15PositioningThe adjacent furniture must be able to withstand aminimum temperature rise of 85°C above the ambienttemperature of the room it is located

16Unpacking the applianceWhen unpacking the appliance please check that the following itemsare contained within the packaging:1 x Baumatic hob2 x Pan

17o Cut a hole in the worktop that corresponds with the drawingshown above and on the previous page.o IMPORTANT: You must have a gap of at least 25 mm

18(A) Sealing strip(B) Clamp(C) Screwo Place the clamp (B) over the holes that match the size of thescrews. There are one set of screw holes in each c

19Gas connectionThis appliance must be installed by a competentperson in accordance with the current versions ofthe following UK (United Kingdom) or R

2User Manual for your BaumaticP75SS/P76SS Pythagora 5 burner 75cmgas hobPF75SS Flush mounted Pythagora 5 burner75cm gas hobP90SS Pythagora 5 burner 90

20o If there are any other fuel burning appliances in the same roomthe current edition of BS 5440: Part 2: should be consulted todetermine air vent re

21o Put the gas seal into the elbow.o Fully tighten the elbow and seal onto the gas rail.o The elbow MUST be pointing in a downwards direction.o Gas p

22o Reassemble all the burners carefully; in particular you shouldmake sure that the flame spreader is correctly placed on theburner.Gas tap maintenan

23If it becomes necessary to replace a gas tap, then you should proceedas follows:o Remove the control knobs, pan supports, burners, hob fixingscrews

24o Replace the cable with one of the same length and in accordancewith the specification given above.o The “green-yellow” earth wire must be connecte

25Baumatic Ltd. Conditions of GuaranteeDear Customer,Your new Baumatic appliance comes complete with a free 12 month guarantee covering both parts and

26Baumatic LtdYou will be mineHeadquartersBaumatic Ltd.Baumatic Buildings,6 Bennet Road,Reading,BerkshireRG2 0QX, United KingdomSales Telephone+44 118

27

3ContentsEnvironmental note 4Important safety information 5 – 7Specifications 8Product & Aperture dimensions 8Product specifications 9Standard acc

4Environmental noteo The packaging materials that Baumatic uses are environmentallyfriendly and can be recycled.o Please discard all packaging mat

5Important safety informationYour safety is of the utmost importance to Baumatic.Please make sure that you read this instruction bookletbefore attempt

6Child Safetyo Baumatic strongly recommend that babies and young childrenare prevented from being near to the appliance and not allowedto touch the ap

7o Great care should be taken whilst using this appliance and whenfollowing the cleaning procedure.o You should not use a steam jet or any other high

8SpecificationsP75SS & P76SSProduct dimensions:Height: 500 mmWidth: 740 mmDepth: 35 mmAperturedimensions:Height: 480 mmWidth: 560 mmPF75SSProduc

9Product specifications:o 1 x 4.50 kW Hypergas burnero 1 x 3.00 kW rapid burnero 2 x 1.75 kW semi-rapid burnerso 1 x 1.00 kW auxiliary burnero Flame f