Baumatic BF16 Manual de Serviço descarregar pdf (Página 3)

3

Important Warnings

•

This appliance is not intended for use by

persons (including children) with reduced

physical, sensory or mental capabilities, or

lack of experience and knowledge, unless

they have been given supervision or in-

struction concerning use of the appliance

by a person responsible for their safety.

•

Children must be supervised to make sure

that they do not play with the appliance.

•

Means of disconnection shall be provided

in the ﬁ xed wiring in accordance with the

Australian wiring rules.

•

During use the appliance becomes hot.

Care should be taken to avoid touching

heating elements inside the oven.

•

WARNING

: Accessible parts will become

hot when in use. To avoid burns and scalds

children should be kept away.

•

A steam cleaner in not to be used for clea-

ning this appliance.

•

Before replacing the lamp bulb, ensure that

the appliance is switched off.

•

Do not use harsh abrasive cleaners or

sharp metal scrapers to clean the oven

door glass since they can scratch the glass

surface, which may result in shattering of

the glass.

IN

STALLATION

This appliance shall be installed only by au-

thorised personnel and in accordance with the

manufacturer's installation instructions, local

electrical wiring regulations. When connection

to electrical supply is completed and oven is

located in its ﬁ nal position, the oven must be

stabilized by using the two chains located at

the rear of the oven. (see ﬁ g. 4)

Each chain must be ﬁ rmly attached to the rear

vertical wall behind the oven. The anchor used

to attach the chains to the rear wall must be of

a type suitable for the purpose.

If the appliance is installed between two cup-

boards, drill a hole on each side of the cup-

boards, pass the chains through the holes and

anchor the chains within each cupboard.

MAKE SURE THE ANTI-TILTING CHAINS

ARE TAUGHT WHEN ANCHORED TO PRE-

VENT THE APPLIANCE TILTING.

If the oven is to be moved for servicing -

THE

CHAINS MUST BE RE-ATTACHED .

ASSEMBLY

The sp

lash back must be ﬁ tted to the cooker.

Rea

d the assembly instructions packed with

the splash back to ensure correct ﬁ tment.

FITTING SHELVES

Clip wire racks to sides of oven walls (Fig.

6 a).

Slide shelves and trays on the guides as

shown (Fig. 6 b)

POSITIONING

Remove the packaging accessories, includ-

ing the ﬁ lms covering the chrome-plated and

stainless steel parts, from the cooker.

Position the cooker in a dry, convenient and

draft-free place.

Any adjoining wall surface

situated within 200mm from the edge of any

hob burner must be a suitable non-combus-

tible material for a height of 150mm for the

entire length of the hob. Any combustible

construction above the hotplate must be at

least 600mm above the top of the pan sup-

ports no construction shall be within 450mm

Installation

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários