Baumatic BHC606BE Manual do Utilizador descarregar pdf (Página 25)

o Switch the appliance off at the socket.

o Open the terminal block on the underside of the hob.

o Unscrew the terminal screws fixing the cable.

o Replace the cable with one of the same length and in accordance

with the specification given on page 23.

o The “green-yellow” earth wire must be connected to the terminal

marked . It must be about 10 mm longer than the live and

neutral wires.

o The “blue” neutral wire must be connected to the terminal

marked with letter (N) - the live wire must be connected to the

terminal marked with letter (L).

My appliance isn’t working correctly

o The cooking zones are not functioning or will not switch

on.

* It has been more than 2 minutes since the appliance was

switched on. You should switch the appliance back on again,

using the ON/OFF button and then switch on a cooking zone.

* The safety lock has been switched on (see the “Locking the hob

top” section for information on how to turn off the safety lock).

* Several cooking zone selection buttons have been pressed at

once. You should only try to switch on one cooking zone at once.

* The safety cut out has been triggered. Press the ON/OFF button

to reset the hob.

* Check that the mains electrical supply to the appliance is correct

and working. Check the mains fuse.

o The residual heat indicator has not come on after I have

switched a cooking zone off.

* The cooking zone has only been turned on for a short period of

time; therefore it did not go above 60°C.

* IMPORTANT: If the cooking zone does appear to be hotter than

60°C and the residual heat indicator has not come on, you

should call the Customer Care Department.

1 2 ... 20 21 22 23 24 25 26 27 28

Sem comentários

Baumatic BHC606BE Manual do Utilizador Página 25