Baumatic PI645 Manual do Utilizador descarregar pdf (Página 29)

My appliance isn’t working correctly

Error codes

Error code Possible causes Solution

F0/F1/F2 Fan failure Contact the Baumatic

Service Department

F3 – F8 Temperature sensor

failure

Contact the Baumatic

Service Department

E1/E2 Abnormal supply

voltage

Check that the power

supply the hob is

connected to is

appropriate. (See the

diagram on page 27).

E3/E4 High zone

temperature

Allow the hob to cool

and then restart it. *

E5/E6 High hob temperature Allow the hob to cool

and then restart it. *

* IMPORTANT: If these error codes appear frequently, then check

that the installation of the hob has been completed correctly. In

particular, pay attention to the ventilation requirements specified in

this manual.

o The cooking zones are not functioning or will not switch

on.

* It has been more than two minutes since the appliance was

switched on. You should switch the appliance on again, using the

ON/OFF button.

* You have not placed an appropriate pan on the zone that you are

trying to get to heat.

* The safety lock has been switched on (see the “Switching on the

safety lock” section for information on how to turn off the safety

lock).

* Several touch control buttons have been pressed at once. You

should only touch one touch control button at a time.

* The safety cut out has been triggered. Press the ON/OFF button

(9) to reset the appliance.

* Check that the mains electrical supply to the appliance is correct

and working. Check the mains fuse.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Sem comentários

Baumatic PI645 Manual do Utilizador Página 29